Signed in as:
filler@godaddy.com
Signed in as:
filler@godaddy.com
Coastal Energy manufactures and sells a variety of asphalt oils for road contractors, waterproofing contractors, and city, state, and county government agencies. Products are used in the pavement preservation and maintenance of asphalt roads, building and resurfacing asphalt highway systems, and waterproofing building foundations and wall surfaces.
Conveniently located with plants across the Midwest, Coastal Energy is dedicated to providing
a comprehensive slate of products and world-class customer service. We also offer multiple rail locations with service on BN, UP, A & M, FSR, and Farm Rail. FMC Transport, our in-house transportation division, is a common carrier of petroleum-based products, including asphalt/ emulsions. With 24/7 on-call dispatch, Coastal Energy and FMC Transport are committed to
a great customer experience with every load.
Products are available for pickup at the plant locations listed below, or they can be delivered to the job site in 5,500-gallon loads.
Please reach us at info@coastal-fmc.com if you have any questions about the right product for your job.
A procedure that is to restore asphalt surfaces by spraying over old surface with new asphalt and adding chips as a wearing course.
Ex: CRS-2, CRS-2P, EA-90, EA 90P, MC-3000, MC-800
Mixes of asphalt and aggregate that are produced without preheating the aggregate. Cold mixes are used for filling potholes, ruts, and other rough areas in the roadway.
Ex: EA-300, MC-250
Products used for preparing a new road surface for paving or a chip ‘n seal.
Ex: MC-30
A procedure similar to a chip ‘n seal, it seals cracks in existing pavement and regenerates existing roadways.
Ex: CRS-2, CRS-2P, EA-90, EA-90P
Identifies that the product has an electro-negative charge. Indicated with an “A.”
Identifies that the product has an electro-positive charge. Indicated with a “C.”
NOTE: The charge of the product is important to know so that one does not mix the same charge aggregate. Think of it as trying to push two magnets together that have the same charge - they will not go together. But take two that have different charges and they will stick to each other. The same reaction occurs with the asphalt emulsions and the aggregates.
Asphalt products that have been blended with dilutants. No water is added, therefore they are also known as dry products.
Ex: MC-800, MC-3000
Indicates that water has been added to the asphalt cement. Indicated with an “E.”
Asphalt products that have had water bonded to the asphalt cement, through the milling process. Since water is added, they are also known as wet products.
Indicates that the product will cure at a medium rate. Indicated with an “MS.”
Indicates the viscosity of the product. A 1 indicates a thinner product, 2 a thicker product.
Rubber or rubber-like products that can be added in the emulsion process. Indicated with a “P,” “S,” or “L.”
Indicates the hardness of the product at 77 degrees F. A product that has a harder penetration is indicated with an “H.”
Indicates that the product will cure at a fast rate. Indicated with an “RS."
Indicates that the product will cure at a slow rate. Indicated with an “SS.”
We use cookies (no, not that kind of cookies) to offer you a better browsing experience and analyze site traffic. By using our website, you agree to our use of cookies.